High precision grinding with correcting dynamic balance during wheel rotation.
New balancebector contains several functions.
・High detection accuracy in low rotation rate
・Dual channel detection system
・Simplified FFT system
Detectable area：120〜300,000min-1
You can measure vibration and correct dynamic balance regardless of rotating in low rate with a large diameter wheel.
High precision correcting is possible with injecting liquids to flange pockets based on the data detected by New balancebector.
Dynamic balance is corrected with injecting water during rotation.
On-the-machine measurement can be done without unloading the workpiece by installing precision touch probe measurement unit.
You can use it equivalent to the quality of the latest 3D measuring device, when you mount it on a high precision machine.
Measurement repeatability of vertical actuation (standard variation)
Measurement repeatability of hole diameter (standard variation)
Measurement on the machine will become much easier when you use a joystick.
Measurement repeatability of 3D form (globe) (standard variation)
Automatic measurement is possible based on the data detected by 3D CAD.
View angle of CCD：0.8×0.7mm
Element resolution of CCD：0.345μm
Measurement repeatability ：±1μm
You can check measurement result by an additionally installed PC.
You can measure and re-grind the workpiece without unloading.
This system makes it easy to measure straightness, and reduces a lot of time to measure.
It can be the device with only “deviation measurement” function.
Measurement of large size workpieces (like T-die, gauge) on the machine will become much easier.
Measuring method which uses 3 non-contact displacement sensors and a short reference gauge.
Absolute form is measured with a reference gauge and its error is 0.33μm/ 1 m (measurement pitch 75 mm) and 0.77μm/ 3 m (measurement pitch 150 mm).
You can easily measure workpieces (like T-die, gauge) without a reference gauge by “deviation component measurement”
You can measure roundness using this unit.
Inquiries
Consultations are free of charge. For those who are thinking of introducing any equipment, a machining test will basically be available at free of charge.
Provide the sales personnel at one of our local sales office with information about required accuracy, workpiece size and material. We will review your requirements at our technical center and reply to your inquiry.
